Swim & Fun 1927 Benutzerhandbuch Seite 55

ELDING 4 / ILLUSTRATION 4 / ABBILDUNG 4 / FIGURE 4
2
3
5
4
6
8
7 9
MV-1927/1928-4-2020 swim-fun.com © All rights reserved Swim & Fun Scandinavia ApS
MV-1927-1928-A5-Filtersystem_BOOK.indb 55 MV-1927-1928-A5-Filtersystem_BOOK.indb 55
Filter system installation instructions
• Once the filter system has been properly assembled, the sand chamber filled with sand
and the hoses connected as described above, you may begin with filtration.
• Do not plug the system in until advised to do so below.
• Make certain the pump is not plugged in to a power supply.
• Before operating the filter system, it is important to ensure that the filter system is
positioned outside the pool and is lower that the pool's water level. The hose connecti-
ons must also be correctly connected and fastened.
• If you haven't done so already, fill your pool with water. Ensure that the water level is
at least 2,5 - 5 cm above the top of the hose intake (Skimmer) and return ports in the
pool.
• The filter system is now vented. If applicable, open the vent screw on the upper side of
the transparent filter cover until the water flows out.
• Release the shut off valve at the intake port (Skimmer) in the pool. If you plugged the
intake port (Skimmer), remove the plug to allow the water to flow into the intake hose.
• With the filter-pump system installed in a location level lower than your pool's water
level – water will automatically flow into the pump-filter system.
• Allow the filter tank to fill with water.
• Check the filter system and the connection hoses for leaks and resolve, if necessary.
Leakage points may possibly arise due to manufacturing tolerances, which need to be
resolved by wrapping teflon tape around the connections before the connection hose
is attached.
• Your filter system is now ready to use.
AFBEELDING 5 / ILLUSTRATION 5 / ABBILDUNG 5 / FIGURE 5
1
ONDERDELEN AFBEELDING E1/L1 /
Cleaning the filter balls
SPARE PARTS ILLUSTRATION E1/L1 /
ERSATZTEILE ABBILDUNG E1/L1 /
PIÈCES DE RE`CHANGE FIGURE E1/L1
The filter balls in the filter tank ensure that dirt particles and floating debris are effective-
ly filtered over a long period of time.
The filter system will reduce its level of performance in accordance with the amount of
contamination in the water. This must be checked at regular intervals.
17
11
10
13
18
14
UK
55
23-Apr-20 10:42:43 23-Apr-20 10:42:43