Restore Factory Settings - HomeMatic IP HmIP-BROLL Installations- Und Bedienungsanleitung

Restore factory settings

1x orange and
1 x green light-
ing
9 Restore factory settings
The factory settings of the device can be restored.
If you do this, you will lose all your settings.
To restore the factory settings of the shutter actuator,
please proceed as follows:
• Remove the rocker (if necessary).
• Press and hold down the system button (A) for 4 s
with a pointed object (e.g. a pen) until the LED will
start flashing orange quickly (see figure 5).
• Release the system button again.
• Press and hold down the system button again for
4 seconds, until the status LED lights up green.
• Release the system button to finish the procedure.
The device will perform a restart. After the restart, you
can again integrate your device into your Homematic IP
system.
54
Test display Once the test
display has stopped,
you can continue.