Operation; Troubleshooting; Command Not Confirmed - HomeMatic IP HmIP-BROLL Installations- Und Bedienungsanleitung

7

Operation

After setup, you can perform initial operating functions
via the push-button rocker switch:
• Short button press upper button: The motor
for the shutters/awnings moves into the corre-
sponding end position.
• Short button press lower button (opposite direc-
tion): The motor stops.
• Long button press: The motor moves into the
corresponding direction until the push-button
is released or the end position of the shutter or
awning is reached.
8

Troubleshooting

8.1

Command not confirmed

If at least one receiver does not confirm a command, the
device LED lights up red at the end of the failed trans-
mission process. The failed transmission may be caused
by radio interference (see "11 General information about
radio operation" on page 56). This may be caused be
the following:
• Receiver cannot be reached.
• Receiver is unable to execute the command (load
failure, mechanical blockade, etc.).
• Receiver is defective.
Operation
51