Alarm Setting - Ventus W266 Gebrauchsanweisung

Searching for Radio-Controlled
Clock Signal
Antenna icon without signal strength indicates the past reception is not successful (Daily synchronization is still
enabled). To enforce searching of radio-controlled time signal immediately, Hold [BARO/ ] button and the
antenna icon flashes. If reception continues to fail, try other locations later. Place the unit away from source of
interference such as mobile phones, appliances, TV etc.
To disable the radio-controlled time reception and stop the daily synchronization, hold [ ] until the antenna icon
disappears.
CLOCK, CALENDAR & TIME ZONE
Press [CLOCK] to toggle display between time and calendar
NOTE: You need to set clock & calendar when your weather station cannot receive radio-controlled time signal in your
location.
NOTE: If your unit can receive radio-controlled clock signal, but you would like to change to different time zone, you can set
the TIME ZONE OFFSET between +12 to –12 hour (it is the time difference between the radio-controlled time and your local
time). If you set TIME ZONE OFFSET other than 0, the "ZONE" icon will appear on clock & calendar display mode.
Follow below steps to set the 12/24 hour format, day/month format, time zone offset, time & calendar
- Hold [CLOCK/SET] button to enter clock setting mode.
- Using [+] or [-] to adjust and [CLOCK/SET] to confirm (or skip) the setting, the following values can be set in
sequence:
Weather Forecast > 12/24hr format > D/M or M/D format > Time Zone Offset > Hr > Min > Yr > > Month
> Date > Temperature unit > Rainfall unit > Wind Speed unit > Pressure unit > Pressure value > EXIT

ALARM SETTING

Press [ALARM] button to show alarm time and the "ALARM" icon will appear. Press again to enable or disable
the alarm. Bell icon " " appears when alarm is enabled.
Hold [ALARM] to enter alarm time setting mode. Press [+] or [-] to enter the desired Hour/ Min values and press
[ALARM] to confirm setting.
SNOOZE & BACKLIGHT
Once the power adapter is connected to the main unit, the backlight will be turned on continuously. To switch off
the continuous backlight, hold [SNOOZE / LIGHT]. Hold [SNOOZE/LIGHT] to activate continuous backlight
again.
When alarm is going off, press [SNOOZE/ LIGHT] to trigger snooze function. To stop alarm for one day, press
"ALARM" key.
In normal display, press SNOOZE/LIGHT for an extended backlight if adapter is not connected.
Downloaded from www.Manualslib.com
Reception is successful
manuals search engine
Reception is fail Reception is disabled