Operation; Maintenance - Makita UC120D Bedienungsanleitung

OPERATION

Lubrication
Fig.9
CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before lubricating the
saw chain.
Always use vegetable oil when pruning fruit trees.
•
Mineral oil may harm trees.
Lubricate the whole saw chain evenly before each use.
Also lubricate it whenever replacing a fully discharged
battery cartridge with a charged one.
Pruning trees
Fig.10
Fig.11
CAUTION:
Keep all parts of the body away from the saw chain
•
when the motor is operating.
Hold the chain saw firmly with both hands when the
•
motor is running.
Do not overreach. Keep proper footing and balance
•
at all times.
Bring the tip guide/lower guide into contact with the
branch to be cut before switching on. Cutting without
bringing the tip guide/lower guide into contact with the
branch may cause the guide bar to wobble, resulting in
injury to operator.
When cutting thick branches, first make a shallow
undercut and then make the finish cut from the top.
Fig.12
If you try to cut off thick branches from the bottom, the
branch may close in and pinch the saw chain in the cut.
Fig.13
If you try to cut off thick branches from the top without a
shallow undercut, the branch may splinter.
If you cannot cut the timber right through with a single
stroke:
Apply light pressure to the handle and continue sawing
and draw the chain saw back a little; then apply the spike
a little lower and finish the cut by raising the handle.
Fig.14
Carrying tool
Fig.15
Always remove the battery cartridge from the tool and
cover the guide bar with the scabbard before carrying the
tool. Also cover the battery cartridge with the battery
cover.

MAINTENANCE

CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before attempting to
Downloaded from www.Manualslib.com manuals search engine
perform inspection or maintenance.
Always wear gloves
•
inspection or maintenance.
Please have your saw chain sharpened at a Makita
•
Authorized Service Center or replace with a new
one if your saw chain does not cut correctly.
Never use gasoline, benzine, thinner, alcohol or the
•
like. Discoloration, deformation or cracks may
result.
Cleaning guide bar
Fig.16
Chips and sawdust will build up in the guide bar groove,
clogging it and impairing oil flow. Always clean out the
chips and sawdust when sharpening or replacing the saw
chain.
Storing tool
Clean the tool before storing. Remove any chips and
sawdust from the tool after removing the chain cover.
After cleaning the tool, run it under no load. Then remove
the battery cartridge from the tool and lubricate the saw
chain and guide bar.
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by Makita Authorized Service Centers, always
using Makita replacement parts.
ACCESSORIES
CAUTION:
These accessories
•
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons.
attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
Various type of Makita genuine batteries and
•
chargers
Saw chain
•
Scabbard
•
Guide bar complete
•
File
•
Hex wrench
•
Chain oil
•
8
when performing any
or attachments are
Only use accessory or