Configuration; Basic Setup; Image Settings Using The Osd Menu - BELINEA 10 Benutzerhandbuch

ENGLISH

CONFIGURATION

Monitor setup under Windows 95/98/ME and
2000:
For Windows 95/98/ME and 2000 users: Installation of
the Belinea driver software is highly recommended. This
can be obtained from your Belinea dealer or downloaded
from Belinea's internet homepage at www.belinea.de.
Choose Support, Downloads, then Driver Files, and
download BELINEA.EXE by clicking on Driver
Download....
Copy the file to a folder on your hard disk (e.g.
C:\BELINEA), and double-click
decompression.

BASIC SETUP

Shortcut for adjusting contrast and brightess .......................................................................................................
You can adjust the contrast and brightness directly by
ƒ
turning the OSD dial ( in figure 4) while the OSD menu
is not active. Turning the dial clockwise displays the
OSD contrast menu, while turning it counter-clockwise

IMAGE SETTINGS USING THE OSD MENU

The OSD menu appears in a window on your screen. It
allows you to select the image settings you want to
change.
Figure 4. Monitor features
14 - Belinea 10 30 26
After decompression you will find the file BELINEA.TXT
in your folder, providing further information on how to
install the Belinea driver software.
Monitor setup under Windows NT 4.0:
Under Windows NT 4.0 no separate setup file is
required. Select the vertical frequency and the number
of colors directly from within the "Settings" à "Control
Panel" à "Display" à "Settings" menu.
it to start
displays the OSD brightness menu. Then turn the dial
clockwise to increase, or counter-clockwise to decrease
the contrast/brightness.
How to open the OSD menu ...................................
1. Press the MENU/EXIT button (
display the OSD menu on the screen.
2. Select the desired function icon using the OSD dial
ƒ
( in figure 4, see the following section "OSD Menu
Icons").
3. Press the ENTER button (
the function.
4. Enter the desired value by turning the OSD dial.
5. To store the setting, press the ENTER button again.
Repeat steps 2-4 to make further adjustments as
needed.
6. The OSD menu will automatically disappear if no
changes are made for more than 10 seconds. The
current settings will be saved. You can also close it
manually by pressing the MENU/EXIT button.
„
in figure 4) to
…
in figure 4) to activate