Introduction; Important Safety Instructions; Guide To Symbols - BELINEA 10 Benutzerhandbuch

INTRODUCTION

This manual will familiarize you with the installation and
use of your Belinea Monitor. Please take the time to
look through these instructions even if you are familiar
with monitors.
We has taken all possible care to ensure that this
manual contains correct, accurate information.
However, the manufacturer cannot assume liability for
any possible errors. In addition, the manufacturer cannot
guarantee that the hardware will meet the purpose you
require. We would appreciate reports of any errors,
suggestions or criticism.
© Copyright 2001
MAXDATA Systeme GmbH
45768 Marl, Germany
www.maxdata.com
All rights reserved. No part of this manual may be reproduced,
processed or distributed in any form (print, photocopy,
microfilm or any other process) or processed by an electronic
system without prior written permission from the manufacturer.
We reserve the right to make changes according to technical
progress. Belinea is an internationally registered trademark.
Other brand names may be registered trademarks and must
be treated as such.

Important Safety Instructions

Some Belinea monitor models come with 2 power cords.
Please ensure you use the UK plug (3 pin) in the UK and
not the European plug (2 pin).
Do not place the monitor in very hot or cold, nor damp or
dusty surroundings. Do not put vases etc. on the monitor,
water may cause short circuits. Do not block or cover the
ventilating openings. All products that produce magnetic
fields, i.e. laser printers, loud-speakers etc., must not be
placed close to the monitor. Do not install this monitor in
areas where too much light or sunshine might directly hit
the screen, otherwise the brightness of the picture will be
poor due to reflections. Refer all servicing and maintenance
to authorised service personnel only!
CAUTION
Do not remove the cover!
Serious electrical shock hazards exist inside this
monitor.
NOTE
Removal of cover invalidates your warranty.
We are all responsible for the environment: this manual was printed from front to back on
paper that was produced without chlorine.
TABLE OF CONTENTS
Introduction ................................................................ 11
Features .................................................................... 12
Important information ................................................. 12
Unpacking ................................................................. 13
Connecting ................................................................ 13
Startup ....................................................................... 13
Configuration ............................................................. 14
Basic Setup ............................................................... 14
Image Settings Using the OSD Menu ........................ 14
OSD Menu Functions ................................................ 15
Caring for Your Monitor .............................................. 16
Preset and user defined graphic modes ..................... 16
Troubleshooting ......................................................... 17
Energy Saving Functions ........................................... 18
Technical Specifications ............................................. 18
Pin Assignment .......................................................... 18

Guide to symbols

The symbols below are used in this manual to indicate
where there is risk of injury or damaging devices or to
indicate especially useful information:
DANGER! Indicates risk of injury. When not
following instructions, severe injury or death
may result.
ATTENTION! Indicates possible damage to
devices. When not following instructions,
devices may be heavily damaged.
IMPORTANT! Indicates hints on operation and
other useful information.
ENGLISH
Operating Instructions - 11