Waeco mobitronic MBC-2000A/S Bedienungsanleitung Seite 25

MBC-2000.book Seite 25 Mittwoch, 30. Juni 2004 5:19 17
battery charger
✓ The green LED illuminates when the charging procedure is completed
Unclamping the battery charger
➤ When the charging procedure is finished, pull the 230-V mains plug from
➤ Unclamp the black minus clamp of the battery charger.
➤ Unclamp the red plus clamp of the battery charger.
➤ Check the fluid level of the battery cells.
➤ Close any opened sealing caps of the battery cells.
➤ Re-clamp the battery to the vehicle system.
➤ Lubricate the battery poles with a bit of terminal grease to protect them
5.2
Connect the battery as follows:
➤ Make sure that the device is not connected to the 230-V mains connec-
➤ Set the B switch (Fig. 8, page 3) to "Start".
➤ Connect the red plus clamp of the battery charger to the positive pole (+)
Downloaded from www.Manualslib.com
and the battery is recharged (Fig. 8 F, Page 3).
The device switches to idle mode.
Caution!
When unclamping the battery charger, make sure not to cause a
short-circuit.
the socket.
Warning!
Make sure to avoid contact with the battery fluid!
If the fluid is below the minimum level in one or more cells, add distilled
water until the fill mark is reached.
Never use normal tap water.
against corrosion.
Providing jump starts
tion.
of the battery (see Fig. 6, page 2).
manuals search engine
Using the battery charger
25