Gb Starting Locomotive Operation; Maintenance Of The Model - Roco E 2 Bedienungsanleitung

GB
Starting locomotive operation
Unwrap model: Take out the model cautiously
with foil (fig. 1).
Operating instructions: Before use is advisab-
le to let the loco go around about 30 minutes for-
wards an 30 minutes backwards without load, to
obtain an optomal circuit and best tractive power.
The smallest radius this model should run is R2 of
the ROCO track system (R2 = 358 mm).
Your locomotive will run smoothly on clean tracks
only. For this purpose we recommend using item
no. 46400, ROCO track cleaning van, or item
no. 10002, ROCO track cleaning rubber, for
remo-ving heavy dirt.
Because of its pinion cog wheel, the loco may touch magnetic switches or uncoupler tracks.
More information about the sound decoder can be found here
10
Fittings: Operation is possible with different cou-
plings (fig. 2). In the enclosed accessory bag you
will find small kits to be fitted on your locomotive.
Please mount them cautiously.
Attention! Use glue only if indicated (fig. 2).
Running in digital mode:
Remove the jumper from the interface.
Finally put the plug of the chip into the interface
as shown in fig. 5.
This model is not equipped for real over-
head operation!
GB

Maintenance of the model

To enjoy your model for a long time, it is necesary
to service it regulary (i.e. after it has been in ope-
ration for approximately 30 hours).
1. Lubrication:
Apply tiny oil drops to spots marked in fig. 4.
We recommend using item no. 10906, ROCO oi-
ler. For lubrication the gearparts (e.g. cogwheels,
worm) we whould recommended our ROCO spe-
cial grease (item no. 10905).
Attention: Please do not oil these parts when
using our grease.
2. Motor Changing:
First remove loco body (fig. 3), and then the motor
(fig. 6).
Assembly: During assembly please take care of
correct position of contacts.
3