Chapter 1. Foreword; Performances Of Packaging Machine; Machine Identification; Weight And Dimensions Of Packed Machine - Minipack MV45L Installations, Gebrauchs Und Wartungsanweisungen

Chapter 1. Foreword

1.1. Performances of packaging machine

This machine represents what the modern technology of vacuum-packing may express at its best. It is flexible, easily
programmable and cheap. It is intended to vacuum-pack foodstuffs by removing oxygen as well as any chemical and
biological pollutant present in the environment. To attain the vacuum level you wish, just program the machine in order to
remove almost all the air contained in the packet. Your product will preserve its organoleptic features, colour, taste, flavour
and nutritive value for a long time.

1.2. Machine identification

In every communication with the Manufacturer, always mention the model and the serial number specified on the plate on
the rear part of the machine.

1.3. Weight and dimensions of packed machine

MV45L Width W = 640 mm
MV48 Width W = 670 mm
MV50 Width W = 830 mm

1.4. Machine weight and dimensions

MV45L Width W = 550 mm
MV48 Width W = 600 mm
MV50 Width W = 770 mm

Chapter 2. Machine installation

2.1. Transport and positioning

When transporting and positioning the machine, it is recommended to handle it with great care!
Neither overturn nor tilt the machine! Oil might come out of the pump and damage the machine.
•
Cut the strap (1) with scissors make sure you protect your eyes by wearing glasses.
•
Remove the upper carton (2).
•
Cut the strap (3) fastening the machine to the pallet.
•
Lift the machine and place it on the working surface. Make sure the machine is placed in a proper environment without
any inflammable and explosive materials or gas.

2.2. Environmental conditions

Working environmental conditions:
•
Temperature from + 5°C to + 40°C
•
Relative humidity from 30% to 90%, without condensation
MACHINE SAFETY FACTOR = IP20
THE AERIAL NOISE MADE BY THE MACHINE IS LOWER THAN 70dB

2.3. Installation diagram

I

Electrical connections

H Gas connection

2.4. Users

2.4.1. Electrical connections
OBSERVE HEALTH AND SAFETY REGULATIONS!
GROUNDING OF THE UNIT IS OBLIGATORY!
Before executing electrical connetions (13), make sure the mains voltage matches the one on the plate (14) on
machine rear and that the earthing contact complies with the safety rules in force. In case of doubts about the mains
voltage, contact the local public supply Company.
2.4.2. Gas connection
Connect gas attachment (15), in case the machine is equipped with such a device, to the gas cylinder through the
proper tube (T).
Pressure of gas plant has to be set on about 2 atm., bearing in mind the max. working pressure is 4 atm.
If the pressure is not correct, act on the knob of the pressure reducer (R).
Length l = 700 mm
Length l = 800 mm
Length l = 780 mm
Length l = 600 mm
Length l = 800 mm
Length l = 690 mm
8
Height H = 1250 mm
Height H = 1300 mm
Height H = 1270 mm
Height H = 1350 mm
Height H = 1400 mm
Height H = 1400 mm
Peso = 114Kg
Peso = 180Kg
Peso = 200Kg
Peso = 101Kg
Peso = 160Kg
Peso = 185Kg