ASROCK X300TM-ITX Handbuch Seite 27

A
B
A
B
B A
B A
B
NUT2 NUT1
Step 4
Move the standoff based on the
module type and length.
The standoff is placed at the nut
location A by default. Skip Step 4 and
5 and go straight to Step 6 if you are
going to use the default nut.
Otherwise, release the standoff by
hand.
Step 5
Peel off the yellow protective film on
the nut to be used. Hand tighten the
standoff into the desired nut location
on the motherboard.
Step 6
Align and gently insert the M.2
(NGFF) SSD module into the M.2
slot. Please be aware that the M.2
(NGFF) SSD module only fits in one
orientation.
20 o
Step 7
Tighten the screw with a
screwdriver to secure the
module into place. Please do
not overtighten the screw as
this might damage the module.
X300TM-ITX
25