Transmit Ringing Tone; Selecting/Deactivating The Ringing Tone - AUDIOLINE SLIM PMR 30 Bedienungsanleitung

Operating the Walkie−Talkies
Resuming channel scanning
Excluding a channel
14

Transmit ringing tone

Selecting/Deactivating the ringing tone

Monitor
30
Service−Hotline Germany: Tel. 0180 5 001388 (cost via Telekom at time of going to print: 14 ct/min)
Downloaded from www.Manualslib.com
X or Y
If a channel found during the channel scanning process should
not be considered for subsequent use, it can be excluded.
All the channels are taken into consideration again when a new
channel scan is started. During the time that the walkie−talkie is
temporarily stopped on the unwanted channel, press and hold
the X / Y for 3 seconds to exclude that channel.
a, 3 sec. X or Y
The ringing tones indicate to other subscribers that you want to
talk to them. A condition for this is that the other subscribers are
using the same channel and CTCSS/CDCSS code.
T
There are 10 ringing tones available for selection. To deactivate
the ringing tone, select the setting 0" (zero).
3 x M
X or Y, P
The Monitor function enables the search for weak signals on the
channel currently set. If you receive an external signal, switch to
a free channel. Always communicate with other subscribers on a
free channel to prevent interference.
a, N
b, N
manuals search engine
Resume channel scanning
The channel is excluded and
channel scanning automatically
resumed
Send ringing tones
Activate programming mode
Select the ringing tone and
confirm it
Monitor the channel
End the monitoring function