Starting The Engine - Zipper Maschinen ZI-RPE120GYN Betriebsanleitung

16.3

Starting the engine

ZIPPER MASCHINEN GmbH
ZI-RPE120GYN
www.Zipper-Maschinen.at
1. Set the fuel switch to the "On" position.
2. Also set the motor on/off switch to the "On" position
Note: The closed position of the choke lever enriches
the fuel mixture to start a cold engine. The open
position provides the correct fuel mixture for normal
operation after starting and for restarting a warm
engine.
3. Move the choke lever to the "Closed" position (only
for cold engine)
4. Set the throttle lever to "half throttle" (= middle
position between "fast" and "slow").
5. Grasp the starter handle and pull it out slowly. The
resistance becomes strongest at a certain point. This
point corresponds to the compression point. Let the
rope roll back a little from this point and then pull it
out powerfully.
6. Switch the choke lever to "Open" as soon as the
engine is running.
7. Open throttle, the engine starts to vibrate.
30