SciCan HYDRIM M2 Installationsanforderungen Seite 35

• Check Blower Motor Capacitors Resistors for visible discolouration and replace if
necessary
• Check program selection
• Perform disinfection chamber temperature profile test using Dios test equipment
(Run both P2 and P3 cycles) – adjust calibration if applicable.
• Reset service cycle counter
• Clean machine
• Conduct electrical safety tests
Downloaded from www.Manualslib.com
• Observe wash arm rotation)
• Door latch
• Salt regeneration valve
• Dosing pump
• Hot water inlet valve
• Cold water inlet valve
• Condenser valve
• Waste pump
• Dryer motor
manuals search engine
34 SD-356 Rev 1