Troubleshooting - Steute Rf Rx Sw868 Montage- Und Anschlussanleitung

RF RxT SW868/915/917/922-NET-M
//
Montage- und Anschlussanleitung / sWave.NET Gateway mit Sensor Bridge und Access Point
Mounting and wiring instructions / sWave.NET Gateway with Sensor Bridge and Access Point
English
Fig. 5: User settings
Basic setup
Once the network and login settings are adjusted, the following
steps are required for a minimal system configuration:
- Create a managed group.
- Assign switches to this group.
Please refer to the product website at www.steute.com for a
detailed description.

Troubleshooting

Error Cause
Mode LED is off No power supply or
internal power sup-
ply unit defective
Ethernet LED is off No network cable,
defective network
cable; network
remote station
inactive
Configuration No network connec-
website cannot be tion established or
displayed Gateway IP and PC
IP not in the same
subnet
Error
Access Point re-
ceives no wireless
telegrams
Maintenance and cleaning
=
We recommend regular maintenance as follows:
1. Remove dirt
Clean enclosure on the outside only. Clean with household cleaning
agents. Do not use compressed air to clean.
Disposal
- Observe national, local and legal regulations concerning disposal.
- Recycle each material separately.
N.B.
The device must not be used in connection with devices that may
directly or indirectly serve health- or life-saving purposes or cause
hazards by operation to human beings, animals or asset values.
Subject to technical modifications.
It is the responsibility of the manufacturer of a plant or machine to
guarantee the correct general function.
steute does not assume any liability for recommendations made or
implied by this description. New claims for guarantee, warranty or
liability cannot be derived from this document beyond the general
terms and conditions of delivery.
Solution
Check power supply,
replace device
Change network
cable; turn on/check
network router or
switch
Check network con-
nection (Ethernet
LED) or adjust PC IP
and reset Gateway
to default settings
8 / 16
Cause
Switch out of
range; antenna not
properly mounted;
wireless receiver
defective
CAUTION
The device contains live parts. They can cause an
electric shock! Do not repair damaged or defective
units, but replace them.
Do not convert or modify the unit.
Solution
Check distance
to switch; check
antenna; replace
device