Herunterladen Inhalt Inhalt Diese Seite drucken

Location Of The Air Dehumidifier; Location; Electric Supply; Power System Fuse Protection - ATIKA ALE 500 N Originalbetriebsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 3
4. Insert the connecting pieces (4) in the legs (2/3). Insert the
legs in the transport handle and secure them to the
enclosure using the 6 hexagon screws M6x40 and the
washers
Assembly transport wheels
1. Secure the wheel axle (5) using the two hexagon head
screws M6x30 and install the cotter pins.
2.
Secure the cotter pins against dropping out by
bending their ends using nippers and slide the washers (Ø
15.5) on the wheel axle.
3. Slide the wheels (6) and the washers on the wheel axle.
Secure the wheels using the securing pins (7).
After assembly, allow the device to stand vertically for
at least one hour before powering it up. In this way, the
refrigerant in it can settle.
L
o
c
a
t
i
o
n
o
f
t
L
o
c
a
t
i
o
n
o
f
t

Location

If possible, the air dehumidifier should be placed in the middle
of the room in order to have a good air circulation in the whole
room.
If this is not possible, locate the air dehumidifier so that air can
be sucked and discharged unhindered.
Keep a minimum distance of 10 cm to walls.
Place the air dehumidifier
 horizontally to ensure that the condensed water can flow off
unhindered
 away from a heat source (e.g. a radiator).
Make sure that windows and doors of the room to be
dehumidified are closed.
The dehumidifier must not be installed near burning
sources, such as an open flame, a switched-on gas
burner or electric heating with glowing spirals.
The device must be set up, operated and stored in a
room with a floor space greater than "A
("A
": see "Technical data  min. room area").
min

Electric supply

Compare the voltage listed on the device's type plate, e.g. 230
V / 50 Hz, with the mains voltage and connect the air
dehumidifier to a suited and and properly earthed electrical
socket.
Use an electrical socket with a rated voltage of 230 V with a
fault-current circuit breaker (30 mA).

Power system fuse protection

10 A
h
e
a
i
r
d
e
h
u
m
i
d
i
f
i
e
r
h
e
a
i
r
d
e
h
u
m
i
d
i
f
i
e
r
".
min
17

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis