CAME Z Serie Bedienungsanleitung Seite 5

ACCESSORIES WHICH CAN BE
CONNECTED TO THIS UNIT
- "Gate open" signal light (10-5);
- Cycle lamp to light the passage area: it re-
mains on from the moment the doors begin to
open until they are fully closed (including the
automatic closing time). If automatic closing
is not activated, the lamp remains on only
during movement.
- Movement fl ashing lamp with pre-fl ashing
option (dip 4 function selector);
- Electric lock;
- LB18 circuit card for battery operation, which
is automatically connected in case of power
failure. Battery is recharged when line voltage
is restored.
- Radiofrequency AF board (see table
page 28).
An auxiliary contact is also provided on ter-
minals A1-A2 for any device that should be
activated at the same time as the opening
command.
OTHER FUNCTIONS AVAILABLE
- Automatic closing. The automatic closing
timer is automatically activated at the end of
the opening cycle. The preset, adjustable
automatic closing time is automatically inter-
rupted by the activation of any safety system,
and is deactivated after a STOP command or
in case of power failure;
- Obstacle detection. When the motor is
stopped (gate is closed, open or half-open
after an emergency stop command), the
transmitter and the control pushbutton will
be deactivated if an obstacle is detected by
one of the safety devices (for example, the
photocells);
- Hammer movement. This feature makes it
easy for the lock to release (the door wings
momentarily press against the closure stops
when the open command is given, which fa-
cilitates release of the electric lock);
- "Operator present" function. Gate operates
only when the pushbutton is held down (the
radio remote control system is deactivated);
- Type of command:
- «open-stop-close-stop» for pushbutton
and radio transmitter;
- «open-close-reverse» for pushbutton
and radio transmitter;
- «open only» for radio transmitter.
ADJUSTMENTS
- Trimmer SENS/VEL = Adjustment of
amperometric sensitivity during operating:
min/max;
- Trimmer SENS/RALL = Adjustment of
amperometric sensitivity during slowdown:
min/max;
- Trimmer TCA = Adjustment of automatic
closing time: 1" to 120";
- Trimmer TL (OP TIME) = Adjusting of the
stop zone (open/closed position, see page
23);
- Faston connectors on the transformer are
used to select normal operating and slowdown
speeds;
Caution! Shut off the mains power
and disconnect the batteries before servi-
cing the inside of the unit.
-5-