Operation; Care And Storage; Technical Specifications - Beurer FB 20 Gebrauchsanleitung

5. Operation

Start-up
• Remove the packaging
• Check the device, power supply and cables for damage.
• Before plugging in the footbath fill it with warm water no higher than the level indicator (approx.
4-5 cm).
• Ensure that the rotary switch is set to " " before the unit is connected to the mains.
• Route the cable safely so that there is no risk of anyone tripping over it.
Make yourself comfortable in a chair and place your feet on the foot rest and apply slight pressure.
Never stand up in the foot bath. The rubber feet on the base of the unit prevent it from sliding.
Set the desired function on the rotary switch:
- Off
- Vibration massage + infrared light
- Heat + bubble massage ,
- Heat + bubble and vibration massage + infrared light ,
Massage roller
You can experience a special massage effect by moving your feet back and forth on the six
massage rollers integrated into the bottom of the footbath. The massage rollers can option-
ally be removed by pulling them firmly upwards.
When installing the rollers, make sure that the roller fixing points downwards, as shown in
the illustration.
Removable attachments
Place the desired attachment on the holder in the centre.
The brush attachment can be used to stimulate the reflex zones in the soles of your feet
The massage attachment provides a soothing massage for your feet and promotes the circulation.
The corn and callus remover is used to remove dead skin cells and calluses.
Note
• Massage of a specific point on the sole of the foot may influence the corresponding organ of
the body. However, we recommend studying relevant literature and asking your doctor before
using point reflex zone massage to achieve the desired effect.
• The footbath can also be used without water.
After use pour the water out over the narrow side of the footbath.

6. Care and storage

After use rinse the unit with tap water. The foot bath can be cleaned with a mild, non-foaming house-
hold cleaner, e.g. neutral vinegar. To dry the air lines, switch to the bubble setting without water for
approx. 1 minute.
Note
• Do not allow water to penetrate the interior of the footbath.
• Store the footbath in its original packaging in a dry area.
• Do not leave it open for an extended period.

7. Technical specifications

Mains connection 220-240 V ~ 50 Hz 120 W
,
11
, ,