Parts Description; Technical Data; Safety; Safety Instructions - LIVARNO LUX IAN 313060 Bedienungs- Und Sicherheitshinweise

Parts description

LC display
1
On / Off touch button
2
On / Off touch button
3
Lamp base
4
USB port
5
Lamp arm
6
Time / Alarm display
7
Calendar display
8
Day of the week display
9
Temperature display
10
Battery compartment
11
Mode button
12
Set button
13
Up button
14
Down button
15

Technical data

Model no.: 14137006L / 14137005L
Illuminant: 18 LEDs (non-replaceable)
Battery: 1 Button cell, type CR2032
USB input: 5 V / 2 A
Operating voltage: SELV 5 V
Rated power: LED max. 4 W
Protection class: III /
Charging time: approx. 2 hours
Lighting time: approx. 1.5 hours

Safety

Safety instructions

Damage due to failure to comply with these instruc-
tions for use will void the warranty! We assume no
liability for consequential damages! We assume no
liability for property damage or personal injury
due to improper handling or failure to observe the
safety instructions!
LIFE AND RISK OF ACCIDENTS
FOR INFANTS AND CHILDREN!
(LC display)
(lamp)
DANGER TO
Introduction / Safety
Never leave children alone and unsupervised
with the packaging material. The packaging
material poses a suffocation hazard. Children
frequently underestimate the dangers.
This device may be used by children aged
8 years and up, as well as by persons with re-
duced physical, sensory or mental capacities,
or lacking experience and/or knowledge, so
long as they are supervised or instructed in the
safe use of the device and understand the as-
sociated risks. Do not allow children to play with
the device. Cleaning and user maintenance must
not be performed by children without supervision.
RISK OF INJURY!
Do not leave the lamp or the packaging material
lying unattended. Plastic film/bags, plastic parts,
etc. are dangerous for children to play with.
Avoid the risk of fatal injury
from electric shock
Always check the Micro-USB cable and the
lamp for damage before charging the lamp.
Never use the lamp if it shows any signs of
damage.
To avoid hazards, if the external flexible lead
on this lamp is damaged it must be replaced
by the manufacturer, their service representative
or an equivalent professional!
The illuminant in this lamp is not replaceable; if
the illuminant reaches the end of its life, replace
the entire lamp.
In the event of damage, repairs or other prob-
lems with the lamp, please contact the service
centre or an electrician.
Never open any of the electrical equipment
(e.g. switches, fitting socket etc.) or insert any
objects into this equipment. This will pose a risk
of fatal injury from electric shock.
Before use, verify that the available mains
voltage corresponds to the required operating
voltage of the lamp (see „Technical data").
Disconnect the Micro-USB cable from the lamp
before assembling, dismantling or cleaning.
This lamp is not suitable for use with
external dimmers and electronic
switches!
GB/IE 15