Start (Scan) - GSScanner GSsmart Benutzerhandbuch

3.4 Start (Scan)

The scanning functionality aims to authenticate CC RFID tags, by identifying the tag as authentic, counterfeit
or suspect. The scan process only handles CC RFID tags, thus other RFID tags placed on a container will not
be scanned.
A scan is started by pressing the buttons marked as (1) or (2), see figure 10.
• Button (1) is used for normal readings.
• Button (2) is used to do an UNDO of a previous read CC RFID tag.
See section 3.4.1 for details on when to use which button.
The scanning is continued as long as the button is being pressed.
When scanning a tag one of 3 results is returned
Authentic: The green LED turns on shortly and the device makes a distinct beep.
Counterfeit: The blue LED turns on shortly and the device makes a distinct beep.
Suspect/None: The blue LED blinks and the device makes a distinct beep.
Already been authenticated and scanned again: The blue LED blinks and the device makes a distinct beep.
Figure 11 Authentic
Tags already authenticated are not re-authenticated in the same scanning process. However if a different tag
is read in between two readings of the same authentic tag then the GSsmart will signal that an authentic tag
is read.
Downloaded from www.Manualslib.com
Figure 10 Start Scan Buttons
manuals search engine
Figure 12 Counterfeit
Figure 13 Suspect
8