Potential Errors; Power Off; Battery Power Level - GSScanner GSsmart Benutzerhandbuch

3.1.1 Potential Errors

In case of an error during startup follow these steps:
1. Power off the GSsmart, see section 3.2 below.
2. Make sure the GSsmart is fully charged, place it in the cradle and wait for the left red LED
to turn off.
3. Turn the device on. If it does not power on, see section 6 for FAQ and support.

3.2 Power Off

To turn off the GSsmart, press the power button as shown in Figure 7. While powering off the left green
LED on the left will turn off as shown in figure 8.
Figure 7 Power Button
3.2.1 Potential Errors
If there is a problem with powering off, the battery may be removed and reinserted. For details on how to
remove the battery, see the device manual, or see section 6 for FAQ and support.

3.3 Battery Power Level

When the battery is low the green LED on the left blinks every 2 seconds.
When the battery power is low the GSsmart may still be able to scan, but it is less effective than before.
7
Downloaded from www.Manualslib.com
Figure 9 - Battery is low
manuals search engine
Figure 8 Power off device