Installation Of A Software Upgrade; Gs Control; Pre Requirements For Running Gs Control - GSScanner GSsmart Benutzerhandbuch

3.5 Installation of a Software Upgrade

If a new version of the application is downloaded when using GS Control (see section 4) then this will be
installed on the device.
When the GSsmart is removed from the USB it re-initializes.
Figure 14 During Initialization the blue LED on the right blinks
If a new version of the application has been downloaded GSsmart installs and test the new application.
If this is successful the blue LED on the right stops blinking for a short while. Hereafter the blue LED on
the right starts to blink again. This means that the installation of new software has been installed and that
the GSsmart is restarted.
When the blue LED on the right turns off it is ready to be used for scanning.

4. GS Control

GS Control is an application that provides administrative functions and support information. The different
menu items are explained below.

4.1 Pre requirements for running GS Control

A Java Runtime environment (JRE) must be installed on the Windows PC onto which the GSsmart is con-
nected.
Starting the GS Control is either done automatically when the device is connected to the PC or by naviga-
ting to the USB directory and running runME.bat
If no JRE is present a page like the one below is displayed to inform you that this should be in place.
Figure 15 The computer is not in compliance
10
Downloaded from www.Manualslib.com manuals search engine