Terms; First Time Usage - GSScanner GSsmart Benutzerhandbuch

This document contains the following sections:
1. Introduction – This section.
2. First Time Usage – A step by step guide for how to start using the GSsmart
3. Basic Operations – This section contains a general description of how to power on and off
the GSsmart, how read results and errors are being informed to the user.
4. GS Control Menu – This section describes how to use the maintenance application where
the user can change settings, see an about screen, and how to synchronize the GSsmart.
5. Errors – This section contains a description of potential errors and corrective actions.
6. FAQ – This section describes how to access the FAQ and support.

1.1 Terms

Authentic: Is how a genuine tag is identified by the GSsmart.
CC RFID tags: RFID tags attached to CC Containers see figure 1.
Counterfeit: Is how a non genuine tag is identified by the GSsmart.
Ethernet: Local network provided by the user, used to establish a connection to the
Internet.
LED: Lights on the GSsmart, see Figure 3. If the left light is red then the GSsmart is
charging. If the left light is green then the GSsmart is turned on. The LED on the right are used
to inform the user about device status during initialization and when reading tags.
PANMOBIL: The Manufacturer of the GSsmart.
Suspect: Is the result of an incomplete reading of a CC RFID tag or a defect CC RFID tag. USB:
The USB is used to charge and synchronize the GSsmart via GS Control
application, see figure 3.

2. First Time Usage

The first time the GSsmart is turned on it has to synchronize with the server before it can scan.
Follow these steps to prepare the GSsmart.
1. Power on the GSsmart.
2. Connect the GSsmart to a Windows PC via the USB port.
3. Starting the GS Control is either done automatically when the device is connected to
the PC or by navigating to the USB directory and running runME.bat.
4. When the GS Control is started you should perform a Synchronization
(see section 4.2).
5. After a successfully Synchronization remove the GSsmart from the USB on the Win-
dows PC.
6. When removed the GSsmart re-initializes and during this the blue LED on the right
is blinking. When initialization is complete the blue LED on the right is turned off and
the GSsmart can be used for scanning.
5
Downloaded from www.Manualslib.com manuals search engine