WMF 3 Gebrauchsanweisung Seite 14

14
Downloaded from www.Manualslib.com manuals search engine
Any remaining food which has dried onto the mixing gadgets
can be soaked in lukewarm soapy water before cleaning.
CAUTION: never clean the appliance or mains cable in the
dishwasher! Never immerse the appliance, mains cable or mains
plug in water or other liquids. Never pour water or other liquids
over the appliance or place the appliance on wet or damp
surfaces. Wipe the appliance and mains cable with a damp (but
not too wet) cloth. Dry the appliance and the mixing gadgets
carefully. Leave the components to air dry for a few minutes if
required.
Do not use any abrasive cleaning agents.
For UK use only
• This product is supplied with a 13 A plug conforming to BS
1363 fitted to the mains lead. If the plug is unsuitable for your
socket outlets or needs to be replaced, please note the follow-
ing. If the plug is a non-rewireable one, cut it from the mains
lead and immediately dispose of it. Never insert it into a socket
outlet as there is a very great risk of an electric shock.
• The replacement of the plug at the mains lead has to be done
according to the following instructions:
• Important: The wires in this mains lead are coloured in accor-
dance with the following code:
blue Neutral
brown Live
As the colours of the wires in the mains lead of this
appliance may not correspond with the coloured markings
identifying the terminals in your plug, proceed as follows:
• the wire which is coloured blue must be connected
to the terminal which is marked with the letter N
or coloured black,
• the wire which is coloured brown must be connected to the
terminal which is marked with the letter L or coloured red.
• Do not connect any wire to the terminal which is marked
with the letter E or by the earth symbol, or coloured green or
green and yellow.
• If a 13 A (BS 1363) plug is used it must be fitted with
a 3 A fuse conforming to BS 1362 and be ASTA approved.
If any other type of plug is used, the appliance must be
protected by a 5 A fuse either in the plug or adapter or at
the distribution board. If in doubt - consult a qualified
electrician.
• Never use the plug without closing the fuse cover.