Hangar 9 Composite QQ Yak-54 2.6m Bedienungsanleitung Seite 32

rudder and tail gear installation • • •
4
Drill marked locations, using a 1/8-inch drill bit
32
Downloaded from www.Manualslib.com
5
Run the screws in and out and apply thin CA to the holes to harden the wall.
Once CA is dry, mount the T-bracket.
manuals search engine
6
Temporarily mount the tail gear as forward as possible. Be careful not to miss
the wood block location that tail gear will be mounted on. Using a felt pen,
mark the screw mounting locations.