Specifications; Additional Safety Rules - Makita 9741 Betriebsanleitung

ENGLISH
1 Hex wrench
2 Spindle
3 Wheel
4 Hex wrench
5 Output shaft
6 Notch
7 Pin

SPECIFICATIONS

Model
Wheel size (Diameter x Width) .......... 100 x 120 mm
No load speed (RPM) ...................................... 3,500
Dimensions (L x W x H) ........... 310 x 185 x 182 mm
Net weight ....................................................... 4.2 kg
• Due to the continuing program of research and
development, the specifications herein are subject
to change without prior notice.
• Note: Specifications may differ from country to
country.
Power supply
The machine should be connected only to a power
supply of the same voltage as indicated on the
nameplate, and can only be operated on single-phase
AC supply. They are double-insulated in accordance
with European Standard and can, therefore, also be
used from sockets without earth wire.
Safety hints
For your own safety, please refer to enclosed safety
instructions.
These symbols mean:
Read instruction manual.
DOUBLE INSULATION

ADDITIONAL SAFETY RULES

1. Inspect for and remove foreign matter such as
nails, screws, etc. from the workpiece surface
before operation.
2. Secure the workpiece firmly.
3. Do not wear gloves during operation.
4. Hold the machine firmly with both hands.
5. Keep hands away from rotating parts.
6. Do not leave the machine running. Operate the
machine only when hand-held.
7. Never attempt to use with the machine held
upside down in a vise, etc.
SAVE THESE INSTRUCTIONS.
Downloaded from www.Manualslib.com
Explanation of general view
8 Wing nut
9 Front roller
0 Cover plate
q Dust port
w Joint
e Switch trigger
manuals search engine
OPERATING INSTRUCTIONS
9741
Removing or installing wheel (Fig. 1 & 2)
Important:
Always be sure that the machine is switched off and
unplugged before removing or installing the wheel.
To remove the wheel, insert one hex wrench into the
end of the spindle and another hex wrench into the
end of the output shaft. Turn the hex wrench in the
output shaft clockwise while securely holding the hex
wrench in the spindle so that the wheel cannot
revolve. Pull the output shaft out of the wheel. Move
the wheel slightly away from the spindle and remove
the wheel from the machine.
NOTE:
The output shaft has a left hand thread.
To install the wheel, follow the removal procedures in
reverse. When installing it, be sure to align the
notches in the wheel with the pins on the spindle.
Adjusting front roller (Fig. 3)
The front roller allows you to apply uniform pressure
to the workpiece. To adjust the front roller, set the
machine on a flat surface and loosen the wing nut.
Adjust the front roller up or down until the clearance
distance (D) is about 2 mm. Tighten the wing nut
securely.
Connecting to dust collector (Fig. 4)
The use of a dust collector makes sanding operations
clean and dust collection easy. To connect a dust
collector, open the dust port by sliding the cover plate
up and in a clockwise direction. Attach the joint onto
the dust port. Now a dust collector can be connected
to this machine.
CAUTION:
When not using a dust collector, close the dust port
opening with the cover plate.
Switch action (Fig. 5)
CAUTION:
Before plugging in the machine, always check to see
that the switch trigger actuates properly and returns to
the ''OFF'' position when released.
To start the machine, simply pull the trigger. Release
the trigger to stop. For continuous operation, pull the
trigger and then push in the lock button. To stop the
machine from the locked position, pull the trigger fully,
then release it.
r Lock button
t Grip
y Handle
u Limit mark
i Screwdriver
o Brush holder cap
3