Removing The Rj45 Connecting Cable; Installing The Frequency Inverter 1 687 023 703; Connecting The Frequency Inverter 1 687 023 703 - Bosch 1 687 011 538 Montageanleitung

en | 14 | 1 687 011 538
2.4

Removing the RJ45 connecting cable

 8: RJ45 connecting cable
1. Unplug the connector from the RJ45 connecting
cable  9 (1) at connection X29 on control board A1.
— If there is an additional ground cable at the RJ45
connecting cable, remove the ground cable from
the grounding point.
2. Remove the RJ45 connecting cable
EPS 200.
 9: Removing the RJ45 connecting cable
---Separator---
2.5 Installing the frequency inverter 1
687 023 703
Connecting to the wrong voltage can damage the
frequency inverter.
1. Prior to installing, ensure that the allowed voltage
range of the frequency inverter 1 687 023 703 (see
rating plate) is compatible with the voltage of the
EPS 200.
— Do not install the frequency inverter if the voltage
range of the frequency inverter does not match
the voltage of the EPS 200.
2. Prior to installing, ensure that all ventilation
openings on the frequency inverter are
unobstructed.
3. Place the frequency inverter on the mounting plate
of the EPS 200 and fasten it to the mounting plate
using 4 hex socket head cap screws and washers.
---Separator---
2.6 Connecting the frequency inverter 1
687 023 703
1. Open the cover  10 (1).
2. Release the electrical cabinet lock
3. Open the cover over the terminals
1 689 978 635 | 2019-01-01
 9 (2) from the
 10:
4. Remove the internal cover over the terminals
(1)
 11:
5. Remove the rear cover over the terminals.
6. Fasten the grounding plate
cable to the frequency inverter using 2 screws,
spring washers and
 12:
(2).
 10
 10 (3) .
Frequency inverter 1 687 023 703
.
Frequency converter 1 687 023 703 opened
 12 (1)
washers 12 (2)
Grounding plate
Connect the frequency inverter with the aid of
the circuit diagram.
 11
with the motor
.
Robert Bosch GmbH