Bosch 1 687 011 538 Montageanleitung Seite 13

 4: Attaching the spacers
2. Attach 4 ribbon cables to the connections X18, X19,
X20 and X21 on control board A1
— Pay attention to the connector coding when
attaching them. The connector coding
matches pin 1 on the circuit board.
 5: Connecting the ribbon cables
3. Place circuit board A2 on the spacers
Robert Bosch GmbH
 6:
4. Attach 4 ribbon cables to the connections X1, X2, X3
and X4 on circuit board A2
( 5 ).
— Pay attention to the connector coding when
 5 (1)
1
 7:
( 6 ). ---Separator---
Assembling circuit board A2
( 7
attaching them. The connector coding
matches pin 1 on the circuit board.
Connecting the ribbon cables
1 687 011 538 | 13 | en
).
 7 (1)
1
1 689 978 635 | 2019-01-01