Fitting The Interior Lindea Decor; Assembling The Sauna Benches; Mounting The Exterior Lindea Decor; Installing The Glass Door - Sentiotec Lindea-V-L-T-L Montageanleitung

Installation instructions, only for experts

3.5. Fitting the interior Lindea decor

Mount the interior decor elements with 8 screws each, starting at the side walls
W1 and W8. Take account of the position of the ventilation slot.
When mounting the Lindea decor elements on the rear wall, make sure the
distances to the sides are correct.
Mount the cover strip (633x40x40) over the glass.
Fit the Lindea decor roof elements. Make sure the cover for the sensor above
the heater is correctly positioned.

3.6. Assembling the sauna benches

Mount the support slats of the sauna benches with adjustable head piece on
the rear walls so that the upper edge is 845 mm high and 50 mm from the side
wall. Before mounting the sauna benches, drill the holes to guide cables for the
LED through.
Screw the sauna benches to the bench support slats and the bench feet from
below.

3.7. Mounting the exterior Lindea decor

Mount the exterior decor elements with 8 screws each, starting on the side walls
next to the glass elements.
Mount the exterior decor elements above the glass.

3.8. Installing the glass door

Screw the two door fittings onto the glass element, making sure that they are
straight and that the doors open outward.
The alignment of the fittings is achieved by adjusting / rotating both
plastic inserts.

3.9. Installing accessories

Mount the ventilation slide.
The door handles are screwed together from the inside.
Fit the door magnet and sleeve plate
p. 13/32
EN