MA lighting MA 4Port Node Anleitung Seite 42

Save Configuration /settings
You can save the settings of MA 4Port Node only the the hard drive of a grandMA2 console/onPC.
Open menu SETUP / NETWORK / MA NETWORK CONFIGURATION / DMX NODES and press button
SAVE TO DEFAULT.
NOTE: With command SAVE SHOW settings of the MA 4Port Node are not stored; settings must be stored with
SAVE TO DEFAULT!
Load Configuration /settings
Open menu SETUP / NETWORK / MA NETWORK CONFIGURATION / DMX NODES and press button
LOAD FROM DEFAULT
If you have integrated additional 4Ports into the Show or exchanged a 4Port, after having saving the
configuration, these 4Ports will not be taken into account when loading this configuration (even if the IP address
wasn't changed). You will first have to configure these „new" 4Ports and then create a new configuration file using
SAVE CONFIG.
Downloaded from www.Manualslib.com manuals search engine
MA 4Port Node
Data
Transport
Safety
instructions
Safety and
environmet
Quickstart
Connect
Quickstart
ON / OFF
Maintenance
Conformity
41