MA lighting MA 4Port Node Anleitung Seite 40

Update from grandMA2 console or onPC (do not use in live situation)
The 4Port Node can be updated from a grandMA console or using the onPC software. To do so, the 4Port Node
must be present in the same network as the console (grandMA2, grandMA2 light, grandMA2 ultralight, or
grandMA2 onPC), i.e. the first 3 IP address groups must be identical. This very console must run the desired
software version (2.8 or higher).
If the cell „version" has a red background, the 4Port Node runs a software version different from that of the
console or onPC. In this case, you have to adapt the software versions as follows:
create an USB-stick (FAT 32) with installation programm
Open menu SETUP / NETWORK / MA NETWORK CONFIGURATION / DMX Nodes at the console or onPC.
Connect USB-stick with the console.
Select the appropriate MA 4Port Node in the overview.
Press the button SOFTWARE UPDATE. Nach dem automatischen Reboot des MA4Port Node muss das Feld
"Version" grau unterlegt sein.
NOTE: if the warning "waiting for update" appears in the display, the version update is unimplemented .
Repeat the update procedure (see above
Downloaded from www.Manualslib.com
).
manuals search engine
4port_v1.x.y.update
MA 4Port Node
Data
Transport
Safety
instructions
Safety and
environmet
Quickstart
Connect
Quickstart
ON / OFF
Maintenance
Conformity
39