Tips And Hints; Use; Cleaning And Storage - MAXXMEE 01114 Gebrauchsanleitung

EN

TIPS AND HINTS

• Always clean mattresses on both sides.
• We recommend cleaning new mat-
tresses once a month. Older mattress-
es should initially be cleaned every
day for a week. We then recommend
cleaning them once a month.
• The HEPA fi lter should be replaced
every 12 – 18 months; the UV-C
lamp (13) should be replaced every
12 – 24 months. If you have any
questions about spare parts, please
contact the customer service depart-
ment via our website:
www.dspro.de/kundenservice

USE

Please Note!
■
The device should only be used if it
has been fully and correctly assem-
bled! The dust container and the
fi lter must be inserted and must not
be damaged! If the dirt were to get
inside the motor unit, this could dam-
age the motor.
■
Make sure that the safety switches of
the UV-C lamp are not blocked!
1. Plug the mains plug into a properly
installed plug socket that is easily
accessible.
2. Place the device down fl at on the
surface which is to be cleaned.
3. Press the On / Off switch (1) to switch
on the device. The device starts to
vacuum and the UV-C lamp (13) and
the vibration head (10) switch on. The
UV control lamp (4) lights up.
 
The vibration shakes up the
surface which is to be cleaned
and the dust which is agitated
is sucked in through the suction
opening (11).
12
4. Guide the device very slowly and
evenly over the surface which is to be
cleaned.
5. After vacuuming, press the On / Off
switch to switch off the device. The
UV control lamp goes out.
6. Pull the mains plug out of the plug
socket.

CLEANING AND STORAGE

Please Note!
■
Empty the dust container each time af-
ter you use the device. The fi lter must
also be regularly cleaned in order to
prevent overloading of the motor.
■
Do not use any sharp or abrasive
cleaning agents or cleaning pads to
clean the device. These may damage
the surface.
• Make sure that the mains plug has
been pulled out and the device is
disconnected from the power.
• Wipe down the motor unit (3) if nec-
essary with a damp soft cloth.
Then dry with a soft cloth.
• Wipe out the recess for the dust con-
tainer (5) with a duster.
Cleaning the Dust Container and
HEPA Filter
1. Reach into the recess in the dust con-
tainer (5) and pull it up and out of the
motor unit (3).
2. Pull the HEPA fi lter out of the dust
container.
3. Empty the dust container.
4. Wipe out the dust container with a dry
duster if necessary.
5. Tap out the HEPA fi lter and clean it
with a soft brush if necessary. Please
Note: For thorough cleaning, the fi lter
can be rinsed under running, cold (!)
water.