Replacing The Lamp; Closing The Door; Installation; Electrical Connection - Electrolux IK2070LI Benutzerinformation

Problem
Upper or lower
square is shown in
the temperature dis-
play.
dEMo appears on
the Display.

6.1 Replacing the lamp

The appliance is equipped with a longlife
LED interior light.
Only service is allowed to replace the
lighting device. Contact your Service Cen-
ter .

6.2 Closing the door

1. Clean the door gaskets.

7. INSTALLATION

WARNING!
Read the "Safety Information"
carefully for your safety and cor-
rect operation of the appliance
before installing the appliance.
7.1 Positioning
Install this appliance at a location where
the ambient temperature corresponds to
the climate class indicated on the rating
plate of the appliance:
Possible cause
The door is not closed
correctly.
The temperature regulator
is not set correctly.
An error has occurred in
measuring the tempera-
ture.
The appliance is in dem-
onstration mode (dEMo).
2.
3.
Cli-
mate
class
SN
N
ST
T

7.2 Electrical connection

Before plugging in, ensure that the volt-
age and frequency shown on the rating
plate correspond to your domestic power
supply.
Solution
Refer to "Closing the door".
Set a higher temperature.
Call your service represen-
tative (the cooling system
will continue to keep food
products cold, but temper-
ature adjustment will not be
possible).
Keep pressed approximate-
ly 10 sec. theOK button
since a long sound of buz-
zer is heard and the Display
shut off for a short while:
appliance start works regu-
larly.
If necessary, adjust the door. Refer to
"Installation".
If necessary, replace the defective
door gaskets. Contact the Service
Center.
Ambient temperature
+10°C to + 32°C
+16°C to + 32°C
+16°C to + 38°C
+16°C to + 43°C
ENGLISH 61