Electrolux IK2070LI Benutzerinformation Seite 60

60 www.electrolux.com
Problem
The compressor
does not start im-
mediately after
pressing the Action
Freeze or Shopping
function, or after
changing the tem-
perature.
Water flows on the
rear plate of the re-
frigerator.
Water flows into the
refrigerator.
Temperature cannot
be set .
The temperature in
the appliance is too
low/high.
The temperature in
the refrigerator is
too high.
The temperature in
the freezer is too
high.
There is too much
frost.
Possible cause
The product temperature
is too high.
The room temperature is
too high.
This is normal, no error
has occurred.
During the automatic de-
frosting process, frost de-
frosts on the rear plate.
The water outlet is clog-
ged.
Products prevent that wa-
ter flows into the water
collector.
Action Freeze or Shopping
functions switched on.
The temperature regulator
is not set correctly.
The door is not closed
correctly.
The product temperature
is too high.
Many products are stored
at the same time.
There is no cold air circu-
lation in the appliance.
Products are too near to
each other.
Food is not wrapped cor-
rectly.
Solution
Let the product tempera-
ture decrease to room tem-
perature before storage.
Decrease the room temper-
ature.
The compressor starts after
a period of time.
This is correct.
Clean the water outlet.
Make sure that products do
not touch the rear plate.
Switch off Action Freeze or
Shopping manually, or wait
to set the temperature until
the function has reset auto-
matically. Refer to "Action
Freeze or Shopping func-
tion ".
Set a higher/lower tempera-
ture.
Refer to "Closing the door".
Let the product tempera-
ture decrease to room tem-
perature before storage.
Store less products at the
same time.
Make sure that there is cold
air circulation in the appli-
ance.
Store products so that
there is cold air circulation.
Wrap the food correctly.