Factory Settings - Seltron SCC40 Bedienungsanleitungen

Para-
Function
meter
F3.18 SWITCH-ON DELAY /
CIRCULATION PUMP
STANDBY TIME
F3.19 MIN/MAX TEMPERATU-
RE LIMITATION
F3.20 SENSOR FOR MIN/MAX
TEMPERATURE LIMI-
TATION

FACTORY SETTINGS

In the menu "FACTORY SETTINGS" there are software tools to help with setting the
controller.
RESET OF ALL CONTROLLER PARAMETERS
Restores all settings of parameters P1, P2, S1 (except S1.1), S2, S3, W, F1,
F2* and F3* to default values.
RESET OF TIME PROGRAMS
Restores default time programs.
RESET OF ALL CONTROLLER SETTINGS AND RESTART INITIAL SETUP
Restores all parameters to default values and starts the initial setup.
SAVE USER'S SETTINGS
Save current parameter values as user's settings.
All sensors marked with an error (ERR) are reset to status - - - (disconnected
sensor).
LOAD USER'S SETTINGS
Load previously saved user's settings.
* Depends on the controller model.
Service settings manual
Parameter description
This function delays activation of output for setted time.
Output is activated when setted delay time expires.
REMARK: If delay time is longer as time of switch-on
period the output won't activate.
Setting 0 means there is no delay and the output should
activate immedately and stay activated for the whole time
of switch-on command.
Setting if controller should respect min. and max. tempe-
rature limitations of certain sensor by control of output.
This function is usefull by thermostatic operation of
output, where min. and max. temperature limitations of
particular sensor should also be respected.
Selection of sensor for the MIN/MAX limitation.
Before performing of the commands stated above, the
controller requires a confirmation of the selected com-
mand.
40
Setting range
0 ÷ 3600 s
0- NO
1- MIN OFF
2- MAX ON
3- MIN OFF & MAX ON
4- MIN ON
5- MAX OFF
6- MIN ON & MAX OFF
1- T1 5- T5
2- T2 6- T6
3- T3 7- T7
4- T4
Default
value
0
0
5*