Manual Mode - Seltron SCC40 Bedienungsanleitungen

OPERATION MODE SELECTION
In group "OPERATION MODE" select the required controller operation mode. You can select
between automatic mode, controller switch-off and manual mode.
You choose the required mode by pressing buttons
ing button .
You exit the setting by pressing button
Description of operation mode:
Automatic operation
Heating is active.
In the automatic operation mode, the controller enables activation and deacti-
vation of additional energy sources (for example: oil boiler, heat pump, electric
heater, etc.).
To activate or deactivate additional sources, select the
when the automatic operation mode has already been selected. A new screen
with additional sources will appear, where you can move through sources with
buttons
select the source you wish to activate or deactivate. Symbol
begin to flash. You can change the source status with buttons
Exit the setting by pressing the
Controller switch-off
Controller is not performing system control and switches off all outputs.
All temperatures are still measured and shown.
active and able to switch on output.

Manual mode

This mode is used for testing the heating system or in case of a malfunction.
Every output can be manually activated or deactivated.
* Depends on model of controller.
User and settings manual
.
and . By pressing the
20
,
button,
button.
Protection functions are still
By pressing buttons
move through move among individual out-
puts R1-R6*. Select the output of which
state you want to change by pressing the
button. Values ON, OFF, AUTO or pump
RPM 40 %, 55%, 70 % and 85 % will begin
to flash. Now you can change the output
status with buttons
Confirm the selection by pressing the
button.
Exit the setting by pressing the
and confirm it by press-
icon again,
or will
and
and
and .
button.
.
,