Photonic F3000 Bedienungsanleitung Seite 19

PERIOD
SHUTTER
SYSTEM
FOOTSW.
FOOT DIM SPEED
FOOT DIM STEP
PANEL LOCK
DISPLAY
1% TRIM
RESET
SELF CALIBRATION
*FIRMWARE
Footswitch
In the standard setting, the light source can be shuttered, i.e. switched on/off by means of a footswitch
connected to the relevant port (8). In addition, keeping the footswitch pressed down changes the
brightness (dimming). Once the required brightness is reached, simply release the footswitch. Other
functions can also be programmed depending on the menu setting.
Remote control via USB
The light source can be controlled from the PC via USB (9). You will need a commercial USB cable and
a driver. All protocol information can be obtained on request from the manufacturer.
µs
LIGHT ON | OFF
TOGGLE+DIM
TOGGLE
PUSH ON
PUSH OFF
PRESETS
DUAL KEY
1-100
1-100%
YES, NO
1-100%
ca. 1-1000mA
cycle duration
Start/Stopp of flash
Switch on/off with footswitch, hold footswitch down
for dimming.
Switch on/off with footswitch
Light source activated while pressed
Light source deactivated while pressed
Press to scroll through Presets
Dimming with 2 external key buttons
Dimming speed for TOGGLE+DIM and DUAL KEY
Step size for dimming
Prevents brightness control directly at the device
Display brighness
LED current for 1% setting
Reset to factory settings
Self calibration for flash mode
Version display of the firmware