Photonic F3000 Bedienungsanleitung Seite 17

Filters (not available for all models)
Various filters can be installed as required in the filter holder (5). Simply pull the filter holder out of the
device for this purpose. Only use clean filters approved by the manufacturer.
Please note that the filter can be hot during operation and immediately afterwards!
Light guide adapter (not available for all models)
Some models allow the use of adapters, which can be placed into the light guide connection (4) until it
snaps. For hard fixing the adapter, tighten adapter fixture (13) with allen key.
For installing the light guide, losen (12) and insert light guide into (4). While pressing smoothly the light
guide into the connector (4), gently tighten (12) again. Check that screw (12) really is fixing the light
guide and is not irradiating by the light.
Some light guide - adapter combinations allow a snap-in installation of the light guide without fixing the
light guide with (12). In such case the screw (12) can be replaced by a cover, but store the screw (12)
in a save place for later use.
Please bear in mind that the light guide tip must be in close contact with the optics inside the light source
for maximum light output. Tolerances can cause a small gap between light guide and optics when using
snap-in light guide installation, which lead to losses in luminous flux.
Always Disconnect device from mains when installing an adapter. Please notice, that
adapters can be hot, so let them cool down before changing.
Module (optional)
On the back at (11) special modules can be installed. E.g. an analog module for automated control of
the light source via DIN sockets.