Photonic F3000 Bedienungsanleitung Seite 15

Always keep the ventilation openings of the device free to avoid causing any overheating. Ensure
that the free air circulation is not hindered by anything and that there is a sufficiently large gap between
the ventilation openings and other objects. Keep the environment of the device clean (above all, dust
and lint-free), so that any device fans cannot suck in any dirt.
ATTENTION: dangerous optical radiation, do not look into the light, can injure your eyes
The device emits light with a high intensity! Never look directly into the light, any light-emitting device
openings or into the light guide end as you will risk injury to the eyes. The emitted light is absorbed by
materials and converted into heat. Never cover the light emission aperture of the device or the light
guide outlet end with the hand, any other parts of the body or any materials. To illuminate objects
correctly, always ensure there is an appropriate gap between the object and the light guide outlet end,
and an appropriate brightness level to avoid thermal damage or fire. Never leave the light guide end
lying around freely.
Before cleaning, disconnect the product from the mains and allow it to cool for at least 15 minutes. Use
a dry cloth for cleaning or a cloth moistened with water or a 5% ethyl or isopropyl alcohol solution, but
do not use combustible or flammable liquids under any circumstances. Allow the device to dry thoroughly
before use. If any liquid penetrates the device accidentally, pull the plug immediately and bring the
device to a service point. If dust has collected on the ventilation openings, it must be removed carefully.
Excessively intensive cleaning or the use of solutions that are too concentrated can lead to scratches,
discoloration or other damage to the surfaces of the device.