Troubleshooting - Gastros Switzerland InductWarm 130+ Betriebs- Und Montageanleitung

Radiation may be greater
Never heat dishes without moist food. This could cause the pan to overheat.
Once you have removed the pan after warming, remember to switch the InductWarm® 130+ appliance off,
unless you intend to use it again straight away. This will prevent the appliance from heating up accidentally
should you or someone else place a pan on the warming surface.
Do not heat up tins or other sealed containers, as these can explode! Items that are unsuitable for use
include any dishes that are not specifically intended for induction appliances, as well as metal splash
guards, aluminum foil, cutlery, jewelry, watches, metallic objects, etc.
The induction hob is officially switched on as soon as the rotary switch is moved away from the off position
(red line aligned with status indicator). Whenever the hob is not in use, the appliance must be switched off.

Troubleshooting

Error
No heat, LED is not flashing
No heat, LED flashing
Infrared remote control is not
working
Dish does not get warm enough
34
Cause
No power supply
Power line fuse tripped
Appliance not switched on
Appliance defect
Dish is not detected
Low Battery
Sender and/or receiver are dirty
No electrical contact between
battery and remote control
Incorrect placement of dish
Energy input is not enough
Dish is not induction compatible
Remedy
Plug the appliance in,
check the plug connection
Check and reset the fuse
Check the plug connection, turn on
the power switch on the bottom of
the device
Contact customer service
servicepoint@gastros.swiss
Dish too small or not compatible
for induction
Replace the battery
Clean sender and receiver
Ensure contact between battery
and remote control
Ensure right position above the
induction coil
Increase power level
Check induction compatibility; use
induction compatible dish