Gastros Switzerland InductWarm 130+ Betriebs- Und Montageanleitung Seite 25

Using the external Control Unit (optional)
Repeated pressing of the power selection button lets you cycle through the different warming zones 1, 2, 3, 4 and
Using the Infrared Remote Control (optional)
Press the indicated power button on the remote control. The IR-remote must target the IR-receiver of the external
control unit or directly the device itself (approx. 30cm).
®
The InductWarm 130+ has four different power levels, covering different temperature ranges. The final
temperature in the dish very much depends on the following factors:
•
Quality of the material of the dish (e.g. flat bottom)
•
Quality of the inductive layer of the dish
•
Consistency of the food, surrounding temperature
•
Size of the dish
•
Position of the dish on the induction unit
LED-Status
LED 1 flashing slow
LED 1 illuminated
LED 2 illuminated
LED 3 illuminated
LED 4 illuminated
LEDs are flashing fast
®
The InductWarm 130+ has an integrated dish detection that guaranties that the induction unit is active only if
there is a dish placed on the device. If a dish is detected, the power level can be controlled by pushing the power
selection button either on the device or on the external control panel.
If you remove the dish from the device, the LEDs are flashing fast and the dish detection will turn off the unit into
the standby mode after 10min (default value for auto power off). If you put back the dish before auto power off,
the unit will continue warming on the previously selected power level.
All inductive dishes can be used with the InductWarm
IR-Receiver
Power Selection
Function
Unit in standby mode
Powel Level 1
Powel Level 2
Powel Level 3
Powel Level 4
No dish detected on the unit
®
130+ unit.
25