Gastros Switzerland InductWarm 130+ Betriebs- Und Montageanleitung Seite 26

®
The InductWarm 130+ has an integrated temperature protection to protect the device and the cover material
from overheating. If the default temperature of 90°C has reached, the unit automatically reduces its power level
from level 4 to level 3 (LED 4 is flashing). If the temperature still increases by another 5°C, the device
automatically changes its mode to standby mode for security purposes. A restart is possible after the
®
InductWarm 130+ has cooled down under the protection level. This can last a few minutes.
BUS-Coupling / Network Mode
If you are using the InductWarm
induction units and connect all of them with a BUS-cable. As soon as you press the power selection button on the
external remote unit, this specific device will become MASTER in the network. All other devices will be
VE .
Every 3 seconds the master unit is sending an information to the slave units. When running in network mode the
units can be operated only on the same power level. It is not possible to control each unit individually.
(Note: Valid
device must have an individual device address!)
If there is no dish detected on any of the units of the network, all units will go into standby-mode automatically
after 20 seconds. During network mode the dish detection is not visualized by fast flashing LEDs. Up to 16
®
InductWarm 130+ units can be linked with a BUS-network cable.
USB Connectors
Both, software updates and system parameter updates can be loaded via the USB port. This task should only be
performed by trained service staff.
26
®
130+ in a network, you must connect an external control unit to one of the
- Each