Inhaltsverzeichnis
Werbung
Installation Location
Downloaded from
www.Manualslib.com
Ofrecido por www.electromanuales.com
Plaster board or
thin ply wood, etc.
Pillar or
thick ply wood.
■ Avoid installing in
locations where the
temperature and
humidity are
excessively high,
and where contact
with water is
possible.
These can result in fire
or electrical shock.
■ Do not install close
to an air-
conditioner intake
or outlet.
Do not install in
locations where
there is excessive
amounts of dust,
oily smoke or
tobacco smoke.
Fire could result.
manuals search engine
WARNING
■The wall where the wall-mount unit is to be
installed must be capable of long-term
support of the total load of the plasma display
and wall-mount unit. Measures should also be
taken to ensure sufficient strength to
withstand the force of earthquakes, vibration
and other external forces.
Incorrect installation can cause the plasma display to fall
and cause injury.
Model 50 Total load of the (plasma display + wall-mount unit) = 52.7kg
Installation on a wooden wall
●
Always install so that the load is supported by a piller. If the
strength of the piller is insufficient, add reinforcement. Do
not install on plasters or decorative posts.
Installation on a concrete wall
●
Use commercially available anchors that are capable of
fully supporting the load of the plasma display.
CAUTION
10cm
or more
■ Do not block the
ventilation holes.
10cm
or more
Also provide
sufficient clearance
in regard to the
surroundings to
avoid blocking the
ventilation.
10cm
The internal
or more
temperature could
elevate and possibly
result in fire.
■ Mount only on a
vertical, rigid wall
surface.
The internal
temperature could
elevate and possibly
result in fire.
Injury or damage could
also result from falling.
41
Ge
Werbung
Inhaltsverzeichnis
