Hitachi CMP5000WXE Bedienungsanleitung Seite 44

Stand attaching to the Plasma Display
Step 2. As shown in figure, hook the stand pipe holes onto the screw heads of the installation bolts 1, then slide the stand
upwards to the main plasma display until it engages the installation bolts 1 (once put together with the display, the stand
will slides no more than 19 mm (3/4 inch)).
Step 3. Pass the installation bolts 2 (M8 x 40) through the stand pipes and tighten the installation bolts securely with the included
hexagonal wrench.
Step 4. Tighten the installation bolts 1 securely with the hexagonal wrench provided.
Table top stand
■ Instructions for using the main display packing material as a stand for the working on
the display
◆ Main plasma display packaging setup
Step 1. Construct the stand for the plasma display using the inner box frame and pads shown in the figure above (all pads are
identical).
Step 2. Set the plasma display down on the pads as shown in the figure below.
Step 3. Follow the instructions in Steps 1-4 in "Normal Installation" to attach the stand to the plasma display.
36
Ge
Downloaded from www.Manualslib.com
Ofrecido por www.electromanuales.com
Installation bolts 2 (M8 x 40)
(Step 3)
Slide the stand (Step 2)
Sheet
Outer box
Pad
Plasma display
Pad
Inner box frame
Mirror mat
manuals search engine
Notes
• Place a sheet or protective cover to protect the
display from scratches or damage.
• Assemble only with the plasma display lying flat
on a table or similar surface.
• Insert the bolts vertically in the holes and tighten
them, but do not apply excessive pressure that
tightens them more than necessary.
• Move the stand so that the stand screw holes
and the nuts that connect the main display line
up correctly.
• The display is a 50" model that weighs
approximately 40 kilograms (88 lb) and has little
depth, making the display very unstable. For this
reason, at least two people are required for
setup and installation.
Inner box frame
Pad
Mirror mat
Plasma display
Inner box frame topped by two pads