Inhaltsverzeichnis
Werbung
Installation Location
Plaster board or
thin ply wood, etc.
WARNING
Pillar or
thick ply wood.
CAUTION
■ Avoid installing in
locations where the
temperature and
humidity are
excessively high,
and where contact
with water is
possible.
These can result in fire
or electrical shock.
■ Do not install close
to an air-
conditioner intake
or outlet.
Do not install in
locations where there
is excessive amounts
of dust, oily smoke or
tobacco smoke.
Fire could result.
■ The wall where the wall-mount unit is to be
installed must be capable of long-term
support of the total load of the plasma TV and
wall-mount unit. Measures should also be
taken to ensure sufficient strength to
withstand the force of earthquakes, vibration
and other external forces.
Incorrect installation can cause the plasma TV to fall and
cause injury.
Total load of the (plasma TV + wall-mount unit)
= 26kg ••• CL32-PD2100
34kg ••• CL37-PD2100
37kg ••• CL42-PD2100
●
Installation on a wooden wall
Always install so that the load is supported by a pillar. If the
strength of the pillar is insufficient, add reinforcement. Do
not install on decorative posts or plaster board.
●
Installation on a concrete wall
Use commercially available anchors that are capable of
fully supporting the load of the plasma TV.
10cm
or more
– 3 –
■ Do not block the
10cm
ventilation holes.
or more
Also provide
sufficient clearance
in regard to the
surroundings to
avoid blocking the
ventilation.
10cm
or more
The internal
temperature could
elevate and possibly
result in fire.
■ Install only on a
vertical surface.
Avoid sloped
surface. Also, do
not install facing
upward.
The internal
temperature could
elevate and possibly
result in fire.
Injury or damage could
also result from falling.
Werbung
Inhaltsverzeichnis
