Cleaning The Detergent Dispenser; Frost Precautions - Zanussi ZWT 3207 Benutzerinformation

CLEANING THE DETERGENT DISPENSER

1.
3.
CLEANING THE INLET HOSE AND THE VALVE FILTER
1
1
2
3

FROST PRECAUTIONS

If the appliance is installed in an area where the
temperature can be less than 0 °C, remove the
remaining water from the inlet hose and the drain
pump.
Do this procedure also when you want
to do the emergency drain.
1. Disconnect the mains plug from the mains
socket.
2. Remove the water inlet hose.
3. Remove the drain hose from the rear support
and unhook it from sink or spigot.
4. Put the ends of the drain and inlet hose in a
container. Let the water flow out of the hoses.
2
2.
3
5. Set any selected programme with option
Pumpen/ Vidange Schleudern/ Essorage and
let it operate until the end of the cycle.
6. When no more water flows, install the inlet
hose and the drain hose again.
7. Press the Ein/Aus Marche/Arrêt button to
deactivate the appliance.
WARNING! Make sure that the
temperature is more than 0°C before
you use the appliance again. The
manufacturer is not responsible for
damages caused by low temperatures.
4
O O
90 90
19