Care And Cleaning - Zanussi ZWT 3207 Benutzerinformation

CARE AND CLEANING

WARNING! Refer to Safety chapters.
PERIODIC CLEANING SCHEDULE
Periodic cleaning helps to extend the life of
your appliance.
After each cycle, keep the door and the detergent
dispenser slightly ajar to get air circulation and dry
the humidity inside the appliance: this will prevent
mildew and odours.
If the appliance is not used for a long time: close
the water tap and unplug the appliance.
Indicative periodic cleaning schedule:
Descaling
Maintenance wash
Clean lid seal
Clean drum
Clean detergent dis-
penser
Clean the inlet hose
and the valve filter
The following paragraphs explain how you should
clean each part.
REMOVING FOREIGN OBJECTS
Make sure that pockets are empty and
all loose elements are tied up before
running your cycle. Refer to 'The
laundry load' in 'Hints and tips'.
Remove any foreign objects (such as metal clip,
buttons, coins, etc) that you may find in the inlet
hose filter and the drum. Refer to 'Cleaning the
drum' and 'Cleaning the inlet hose and the valve
filter' paragraphs. If necessary, please contact the
Authorised Service Centre.
EXTERNAL CLEANING
Clean the appliance with soap and warm water
only. Fully dry all the surfaces. Do not use a
scouring pads or any scratching material.
CAUTION! Do not use alcohol,
solvents or chemical products.
18
Twice a year
Once a month
Every two months
Every two months
Every two months
Twice a year
CAUTION! Do not use the metal
surfaces with chlorine-based
detergent.
DESCALING
If the water hardness in your area is high or
moderate, we recommend that you use a water
descaling product for washing machines.
Regularly examine the drum to prevent limescale
and rust particles.
To remove rust particles use only special products
for washing machines. Do this separately from the
laundry wash.
Always obey the instructions that you
find on the packaging of the product.
MAINTENANCE WASH
With the low temperature programmes it is possible
that some detergent stays in the drum. Perform a
maintenance wash regularly. To do this:
• Remove all laundry from the drum.
• Select the cotton programme with the highest
temperature with a small quantity of detergent.
LID SEAL
Regularly examine the seal and remove all objects
from the inner part. Clean it when needed, using
ammonia cream cleanser agent without scratching
the seal surface.
Always obey the instructions that you
find on the packaging of the product.
CLEANING THE DRUM
Regularly examine the drum to prevent rust
particles. For a complete cleaning:
- Clean the drum with special products for stainless
steel. Add a small quantity detergent into empty
drum, in order to rinse out any left residues.
- Run a short cotton programme at high
temperature.
Always obey the instructions that you
find on the packaging of the product.