Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
EFFECT
PRESET
8. Troubleshooting
If problems occur, verify the installation of the camera with the instruction in this manual and with other operating
equipments.
Isolate the problem to the specific piece of equipment in the system and refer to the equipment manual for further
information.
Problem
No video
Videos, but no control
Dark Video
Downloaded from
www.Manualslib.com
D-ZOOM
Activation / deactivation of the digital zoom function
NEGA/POSI
Switches between negative and positive display.
B/W
Selection of colour or b/w picture.
MIRROR
Selection of right, left, reverse picture
PIP
Picture in picture
FREEZE
Select real and still picture
Note
Freeze mode is automatically off, when zoom and focus
operation.
SYNC
Internal (INT), line lock (L/L) or AUTO mode.
Sync phase is adjustable in line lock mode
INIT
Initializes camera (factory preset) PRESET/DEFAULT.
LOAD
Sets camera to default settings (factory preset), FACTORY/
PRESET
SAVE
To store settings (power line interrupt) the programming
has to be saved here.
DNR
Digital noise reduction mode on/off
Note
In the Enhanced Dyamic Range or Low-Shutter mode,
image quality can be decreased. DIS is operated on digital
zoom x2. DNR is disabled in freeze,
Low-Shutter and WDR mode. WDR is not effective in freeze
status.
Possible solution
1. Verify power to all pieces of equipment in the system. The camera LED should be ON.
2. Verify that the video cable is connected correctly.
3. Verify that the lens cap has been removed from the lens or that the ids of the lens
is open.
1. Power down the system for one minute, then re-apply power.
1. Adjust iris
2. Check A/I connections
manuals search engine
26
OFF
OFF
OFF
OFF
OFF
OFF
INT
Preset
Default
Preset
OFF
Werbung
Inhaltsverzeichnis
Fehlerbehebung
