Enabling The Alarm - Silvercrest WE-2200 Bedienungsanleitung Und Serviceinformationen

Enabling the Alarm

After the desired alarm time has been set, you can enable the
alarm as follows:
Press the
"ALARM" [26] appears on the display.
To disable the alarm, press the AL.ON/OFF button [13]
again. The indication "ALARM" [26] disappears.
The device will power on at the set alarm time and will
receive the last tuned-in frequency and frequency band.
Press the On/Off button [7] to switch the device off;
or
press the SNOOZE button [10] to delay the alarm for approx.
5 minutes. After this delay, the device will power on again.
AL.ON/OFF
Even when the alarm function is enabled, you
can use the
remember that the device always powers on with
the last tuned-in frequency and frequency band
as well as the last volume setting.
The alarm function will work only if the device
has been powered off previously.
Multi-Band Tuner WE-2200
button [13].
device as
The indication
usual. However,
English - 17