Dometic CAM1000 Betriebsanleitung Seite 10

Connecting the CAM1000 / BSC01
Key for circuit diagram
No. Designation
1 Green connection plug:
2 Yellow connection plug:
3 Red/black wire:
4 Red wire:
5 Green wire:
6 White wire:
6.1
7 Black wire:
8 Gray wire:
9 Violet wire:
I
NOTE
• In Germany and Austria, special requirements apply for the operation to fulfill the
operating licence.
• CAM1000 / BSC01 may only be operated with the M75LXAHD monitor.
• It is important for the compliant operation of the system that it cannot be switched
off manually. The CAM1000 / BSC01 must therefore be connected via camera
input CAM3 of the M75LX AHD monitor. The corresponding blue control line
switches the system on and off.
The following connections must be implemented:
10
Description
Audio output to loudspeaker
CVBS video output
Buzzer for acoustic signal
Connection to ignition (ACC) 12 V/24 V
R = reverse gear 12 V/24 V
Optical display of objects
Warning sound active
Left turn signal < 10 seconds:
- Optical display of objects
- Warning sound inactive
A blue square appears on the screen.
Warning sound switches active
- After 3 minutes
- Speed >40km/h
Left turn signal> 10 seconds:
- Optical display of objects
- Warning sound inactive
A blue square appears on the screen.
Warning sound switches active
- With turn off of the left turn signal
Connection to ground
Cable bridge for activation of operating mode A or B:
Loop open = operating mode B 165° FOV
Loop closed = operating mode A 140° FOV
GPS output 12 V/24 V for switching on the monitor (blue
line) (C3)
CAM 1000 / BSC 01
EN